Keeping dry under difficult circumstances Mitsubishi Mining Company in Lucerne Valley California had a big problem. The storage silos for their finished cement products had leaks. Water seepage into almost any material is not good and for Mitsubishi it was a huge problem. The leaking water made the powdered cement turn into hardened rock. In one of the storage silos they were getting a lot of chunks of cement rock. Upon further investigation they found that they had pieces of cement as big as cars inside. They were so big that dynamite and jackhammers were used inside the silo to break them down into smaller pieces before they could be removed This cost a lot of money as well as down time. They needed a solution that would stop the leaks and also stand up to the harsh environment of the hot desert and mining conditions. Rubberized Emulsion and Polyester Century Roofing introduced them to a tough waterproofing system that could take the abuse that was dished out from the mining operation as well as the harsh desert climate and continue to stay watertight. The system uses rubberized emulsion, polyester ply sheets and a final layer of white Acu-Flex coating. On top of the storage silos a large layer of cement built up over the years. This had to be removed before waterproofing the deck. Jackhammers were used on the larger pieces of cement and needle guns and grinders removed the material off of the roof deck, perimeter and equipment…a very expensive and time consuming process. Perimeter metal and flashings were primed and two layers of an elastomeric compound and polyester were applied. The original concrete deck was irregular. After the deck was primed, 6 gallons per 100 square feet of rubberized emulsion was applied to the roof deck followed by 1 layer of soft polyester. This process was repeated for a total of 2 layers. Using soft polyester allowed for the waterproofing system to mold to the concrete deck avoiding any air pockets or voids. A final coating of 6 gallons per 100 square feet of rubberized emulsion completed this phase of the job. Acu-Flex White Roof Coating After the rubberized roof cured, Advanced Coating’s Acu-Flex Acrylic material was applied at the rate of 2 gallons per 100 square feet. After the acrylic coating dried and cured 1 gallon per 100 square feet of Acu-Flex Hydro was applied. The coating blocks 100% of the suns UV rays and protects the new system from the hot desert sun. It will also stretch along with the rubberized material underneath, giving the roof flexibility. Once the whole roof system was complete a walking deck was installed to all of the high foot traffic areas. Upon completion Mitsubishi Mining received a 10-year warranty. The job came in on time and on budget Century Roofing has been using rubberized emulsions and acrylics for three generations. We have been combining them with tough polyester reinforcement material for 17 years. If you have tough, difficult or unusual waterproofing concerns we can help. May we put three generations of waterproofing know how to work for you?
|
|
Heavy Layer of Cement 
Cement debris
The roof deck stripped of cement. It is now ready for priming
Equipment and flashings are prepared on the primed roof deck.
After the roof deck was primed all pitch pockets, boxes, flashings and equipment was sealed with Acu-Caulk and Acu-Fabric polyester